D-Link xStack DGS-3620 Reference Manual page 941

Hide thumbs Also See for xStack DGS-3620:

Table of Contents

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

Bootstrap Router: 10.54.71.9

Group Address

---------------

Total Entries: 2

DGS-3620-28PC:admin#

This example shows how to display PIM-SM RP information for 229.1.1.1 which was learned by

Bootstrap Router.

DGS-3620-28PC:admin# show pim rpset group 229.1.1.1

Command: show pim rpset group 229.1.1.1

Group: 229.1.1.1

RP: 10.2.2.2, via bootstrap

Uptime: 00:36:46, expires: 00:01:44

DGS-3620-28PC:admin#

create pim register_checksum_include_data rp_address

This command is used to decide the checksum in register packet will include the data portion or

not. As defined in RFC 4601, the checksum for Registers is done only on the first 8 bytes of the

packet, including the PIM header and the next 4 bytes, excluding the data packet portion. Some

earlier PIM-SM routers will calculate checksum for register packet including data portion. This

configuration makes our routers communicate with those earlier routers smoothly. The default set

is not including data portion.

create pim register_checksum_include_data rp_address <ipaddr>

rp_address - Specifies that the RP will expect to receive a register packet in which the checksum

will be included in the data portion .

<ipaddr> - Enter the IP address used here.

Restrictions

Only Administrators, Operators and Power-Users can issue this command.

Expired Time

------------

Chapters

Table of Contents