D-Link xStack DGS-3620 Reference Manual page 882

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin# config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enabled
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
advertise enabled
Success.
DGS-3620-28PC:admin#
76-4 delete ospf aggregation
Description
This command is used to delete an OSPF area aggregation configuration.
Format
delete ospf aggregation <area_id> <network_address> lsdb_type [summary | nssa_ext]
Parameters
<area_id> - A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
<network_address> - The IP address that uniquely identifies the network that corresponds to
the OSPF Area. The network address format is 'IP address/prefix length'.
lsdb_type - Specifies the LSDB type.
summary - Specifies the LSDB type as summary.
nssa_ext - Specifies the LSDB type as NSSA EXT.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete an OSPF area aggregation settings:
DGS-3620-28PC:admin# delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary
Command: delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
Success.
DGS-3620-28PC:admin#
76-5 show ospf aggregation
Description
This command is used to display the current OSPF aggregation table.
Format
show ospf aggregation {<area_id>}
877