D-Link xStack DGS-3620 Reference Manual page 648

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
52-8 show address_binding
Description
This command is used to display address binding information.
Format
show address_binding {ports {<portlist>}}
Parameters
ports – (Optional) Specify to display the state of IP MAC port binding for all ports.
<portlist> - Enter the list of ports for the display here.
Restrictions
None.
Example
To display address binding information:
DGS-3620-28PC:admin#show address_binding
Command: show address_binding
Roaming state
Trap/Log
DHCP Snoop(IPv4)
DHCP Snoop(IPv6)
ND Snoop
Autosave state
Save Filename
Function Version
DGS-3620-28PC:admin#
To display address binding information for ports 1 to 10:
DGS-3620-28PC:admin#show address_binding ports 1:1-1:10
Command: show address_binding ports 1:1-1:10
ARP:ARP Inspection
Port ARP
----- -------- -------- -------- ---- --------- ----------- --------------
1:1 Disabled Disabled Disabled All
1:2 Disabled Disabled Disabled All
1:3 Disabled Disabled Disabled All
1:4 Disabled Disabled Disabled All
1:5 Disabled Disabled Disabled All
: Enabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
: dhcpsnp.cfg
: 3.96
IP:IP Inspection
IP ND Prot Zero IP
ND:ND Inspection
DHCP Packet Stop Learning
Not Allow Forward
Not Allow Forward
Not Allow Forward
Not Allow Forward
Not Allow Forward
643
Prot:Protocol
Threshold/Mode
500/Normal
500/Normal
500/Normal
500/Normal
500/Normal