D-Link xStack DGS-3620 Reference Manual page 35

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
None.
Restrictions
None.
Example
To show device status, the number 1, 2, 3 etc represent the fan number:
DGS-3620-28PC:admin# show device_status
Command: show device_status
Unit 1:
Internal Power: Active
External Power: Fail
Left Fan
Right Fan
Back Fan
CPU Fan
Unit 2:
Internal Power: Active
External Power: Fail
Left Fan
Right Fan
Back Fan
CPU Fan
DGS-3620-28PC:admin#
2-29 config out_band_ipif
Description
This command is used to configure the out of band management port settings.
Format
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway
<ipaddr>} (1)
Parameters
ipaddress - Specifies the IP address of the interface. The parameter must include the mask.
<network_address> - Enter the IP address of the interface. The parameter must include the
mask.
state – Specify the interface status.
enable - Specifies to enable the interface.
disable - Specifies to disable the interface.
gateway - Specifies the gateway IP address of the out-of-band management network.
: 1, 3 Fail
: 2 Fail
: OK
: Fail
: 1 Fail
: OK
: 2, 4 Fail
: OK
30