Chapter 69 Mld Snooping Multicast (Msm) Vlan Commands - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 69
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority [<value
0-7> | none] {replace_priority}}
config mld_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>] | tag_member_port <portlist>] | state
[enable | disable] | replace_source_ipv6 [<ipv6addr> | none] | remap_priority [<value 0-7> |
none] {replace_priority}}(1)
create mld_snooping multicast_vlan_group_profile <profile_name 1-32>
config mld_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcastv6_address_list>
delete mld_snooping multicast_vlan_group_profile [profile_name <profile_name 1-32> | all]
show mld_snooping multicast_vlan_group_profile {<profile_name 1-32>}
config mld_snooping multicast_vlan_group <vlan_name 32> [add | delete] profile_name
<profile_name 1-32>
show mld_snooping multicast_vlan_group {<vlan_name 32>}
delete mld_snooping multicast_vlan <vlan_name 32>
enable mld_snooping multicast_vlan
disable mld_snooping multicast_vlan
show mld_snooping multicast_vlan {<vlan_name 32>}
config mld_snooping multicast_vlan forward_unmatched [disable | enable]
config mld_snooping multicast_vlan auto_assign_vlan [enable | disable]
69-1 create mld_snooping multicast_vlan
Description
This command is used to create an MLD snooping multicast VLAN and implements relevant
parameters as specified. More than one multicast VLAN can be configured. Newly created MLD
snooping multicast VLANs must use a unique VLAN ID and name, i.e. they cannot use the VLAN
ID or name of any existing 802.1q VLAN. Also keep in mind the following conditions: multicast
VLANs cannot be configured or displayed using 802.1Q VLAN commands and the multicast VLAN
snooping function co-exists with the 802.1q VLAN snooping function.
Format
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority
[<value 0-7> | none] {replace_priority}}
Parameters
<vlan_name 32> - Enter the name of the multicast VLAN to be created. Each multicast VLAN is
given a name that can be up to 32 characters.
<vlanid 2-4094> - Enter the VLAN ID of the multicast VLAN to be created. The range is from 2 to
4094.
remap_priority - (Optional) Specifies the remap priority here.
<value 0-7> - Enter the remap priority (0 to 7) to be associated with the data traffic to be
MLD Snooping
Multicast (MSM) VLAN
Commands
802