D-Link xStack DGS-3620 Reference Manual page 584

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To display the link local address automatic configuration state:
DGS-3620-28PC:admin#show ipif_ipv6_link_local_auto
Command: show ipif_ipv6_link_local_auto
IPIF: System
DGS-3620-28PC:admin#
46-10 config ipif ipv6_autoconfig
Description
This command is used to enable or disable automatic configuration of the IPv6 address using
stateless auto-configuration.
This command is only available for the VLAN IPv6 interface (IPv6 is enabled on the VLAN
interface). By default the auto-configuration option is disabled.
When enabling this configuration, the interface enables IPv6 processing and a router
advertisement containing an assigned global address prefix will be received on this interface from
an IPv6 router. The resulting address that is a combination of the prefix and the interface identifier
will be assigned to the interface.
When disabling this configuration, the obtained global unicast address will be removed from the
interface.
If the default option is specified, it will accord the received router advertisement to insert a default
route to the IPv6 routing table. The type of this default route is SLAAC. It has a higher route
preference than the dynamic default route which learnt from RIPng, OSPFv3, or BGP+. The static
default route has higher route preference than it.
Format
config ipif ipv6_autoconfig <ipif_name 12> state [enable | disable] {default}
Parameters
<ipif_name 12> - Enter the IP interface's name that will be configured here. This name can be up
12 characters long.
state - Specifies the IPv6 automatic configuration's state.
enable - Specifies to enable IPv6 automatic configuration.
disable - Specifies to disable IPv6 automatic configuration.
default - (Optional) Specifies that if a default router is selected on this interface, the default
keyword causes a default route to be installed using that default router. The default keyword
can be specified on only one interface.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Automatic Link Local Address: Disabled
579