D-Link xStack DGS-3620 Reference Manual page 963

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#
81-20 config pim6 register_probe_time
Description
This command is used to configure the PIM6-SM register probe time.
Format
config pim6 register_probe_time <sec 1-127>
Parameters
register_probe_time - Specifies the time before the Register-Stop Timer (RST) expires when a
DR may send a Null-Register to the RP to cause it to resend a Register-Stop message.
<sec 1-127> - Enter the register probe time value here. This value must be between 1 and
127 seconds. The default value is 5 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To configure the register probe time to be 20 seconds:
DGS-3620-28PC:admin# config pim6 register_probe_time 20
Command: config pim6 register_probe_time 20
Success.
DGS-3620-28PC:admin#
81-21 config pim6 register_suppression_time
Description
This command is used to configure the PIM6-SM register suppression time. This is the period
during which a PIM Designated Router (DR) stops sending Register-encapsulated data to the
Rendezvous Point (RP) after receiving a Register-Stop message.
Format
config pim6 register_suppression_time <sec 3-65535>
Parameters
register_suppression_time - Specifies the period during which a PIM DR stops sending
Register-encapsulated data to the RP after receiving a Register-Stop message.
<sec 3-65535> - Enter the register suppression time value here. This value must be between
3 and 65535 seconds. The default value is 60 seconds.
958