D-Link xStack DGS-3620 Reference Manual page 638

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
<millisecond 0-3600000> - Enter the time between 0 and 3600000 milliseconds.
retrans_time - Specifies the amount of time between retransmissions of router advertisement
message in millisecond, and the router advertisement packet will take it to host.
<millisecond 0-4294967295> - Enter the time between 0 and 4294967295 milliseconds.
hop_limit - Specifies the default value of the hop limit field in the IPv6 header for packets sent by
hosts that receive this RA message.
<value 0-255> - Enter the value between 0 and 255.
managed_flag - Specifies to enable or disable the function.
enable - When set to enable, it indicates that hosts receiving this RA must use a stateful
address configuration protocol to obtain an address, in addition to the addresses derived
from the stateless address configuration.
disable - Set to disable to stop hosts receiving the RA from using a stateful address
configuration to obtain an address.
other_config_flag - Specifies to enable or disable the function.
enable - When set to enable, it indicates that hosts receiving this RA must use a stateful
address configuration protocol to obtain on-address configuration information.
disable - Set to disable to stop hosts receiving this RA from using a stateful address
configuration protocol to obtain on-address configuration information.
min_rtr_adv_interval - Specifies the minimum time allowed between sending unsolicited
multicast Router Advertisements from the interface, in seconds. It must be no less than 3
seconds and no greater than .75 * MaxRtrAdvInterval. The default is 0.33 *
MaxRtrAdvInterval.
<sec 3-1350> - Enter the time between 3 and 1350 seconds.
max_rtr_adv_interval - Specifies the maximum time allowed between sending unsolicited
multicast Router Advertisements from the interface, in seconds. It must be no less than 4
seconds and no greater than 1800 seconds. The default is 600 seconds.
<sec 4-1800> - Enter the time between 4 and 1800 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the RA state as enabled and the life_time of the "tiberius" interface to be 1000
seconds:
DGS-3620-28PC:admin#config ipv6 nd ra ipif tiberius state enable life_time 1000
Command: config ipv6 nd ra ipif tiberius state enable life_time 1000
Success.
DGS-3620-28PC:admin#
51-8 config ipv6 nd ra prefix_option ipif
Description
This command is used to configure the prefix option for the router advertisement function.
Format
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr> {preferred_life_time
<sec 0-4294967295> | valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]}(1)
633