D-Link xStack DGS-3620 Reference Manual page 423

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
24-7 config filter dhcpv6_server ports
Description
This command is used to configure the state of filter DHCPv6 server packets on the switch. The
filter DHCPv6 server function is used to filter the DHCPv6 server packets on the specific port(s)
and receive the trust packets from the specific source. This feature can be protected network
usable when a malicious host sends the DHCPv6 server packets.
Format
config filter dhcpv6_server ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specifies that all ports will be used for this configuration.
state - Specifies whether the port's filter DHCPv6 server function is enabled or disabled.
enable - Specifies that the filter option is enabled.
disable - Specifies that the filter option is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the filter DHCPv6 server state to enabled for ports 1 to 8:
DGS-3620-28PC:admin#config filter dhcpv6_server ports 1:1-1:8 state enable
Command: config filter dhcpv6_server ports 1:1-1:8 state enable
Success.
DGS-3620-28PC:admin#
24-8 config filter dhcpv6_server trap
Description
This command is used to enable or disable the filter DHCPv6 server trap state.
Format
config filter dhcpv6_server trap [enable | disable]
Parameters
enable - Specifies that the trap for the filter DHCPv6 server will be enabled. The trap for filter
DHCPv6 server will be sent out.
disable - Specifies that the trap for the filter DHCPv6 server will be disabled.
418