D-Link xStack DGS-3620 Reference Manual page 337

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#
Command: debug bgp all flag enable
Success.
DGS-3620-28PC:admin#
20-39 debug bgp fsm_event
Description
This command is used for setting the flag of debugging information about peer FSM Event.
Format
debug bgp fsm_event [enable | disable]
Parameters
enable - Enable the BGP debug function.
disable - Disable the BGP debug function.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP peer FSM event debug flag to enable:
DGS-3620-28PC:admin# debug bgp fsm_event enable
Command: debug bgp fsm_event enable
Success.
DGS-3620-28PC:admin#
Output Examples: After BGP peer FSM event debug flag to enable, it may print following
information.
BGP: 10.1.1.1-10.2.2.2, [FSM] State Change: Idle -> Connect.
BGP: 10.1.1.1-10.2.2.2, [FSM] Hold-Timer Expiry.
BGP: 10.1.1.1-10.2.2.2, [FSM] State: Open, Event: 3.
20-40 debug bgp packet
Description
This command is used for setting the flag of debugging information about different type of BGP
packets' receiving and sending.
debug bgp all flag enable
332