D-Link xStack DGS-3620 Reference Manual page 972

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
routes. The one that has the higher priority should be used to check the traffic first.
default - Specifies that the policy base route has lower priority than the route in the routing
table.
pbr - Specifies that the policy base route has higher priority than the route in the routing table.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure all packets which match ACL rule profile ID=1 and access ID=1, and then route to
20.1.1.100:
DGS-3620-28PC:admin#config policy_route name danillo acl profile_id 1 access_id
1 nexthop 20.1.1.100 state enable
Command: config policy_route name danillo acl profile_id 1 access_id 1 nexthop
20.1.1.100 state enable
Success.
DGS-3620-28PC:admin#
82-4 show policy_route
Description
This command is used to display the switch's current policy route rules.
Format
show policy_route
Parameters
None.
Restrictions
None.
Example
To display the switch's current policy route rules:
967