D-Link xStack DGS-3620 Reference Manual page 956

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
group - (Optional) Specifies the IPv6 multicast group address.
<ipv6addr> - Enter the IPv6 multicast group address used here.
source - (Optional) Specifies the IPv6 source address. If this parameter is chosen, the (S, G) or
(S, G, rpt) entries will be displayed; otherwise the (*, G) entries will be displayed.
<ipv6addr> - Enter the IPv6 source address used here.
If no parameter is specified, the system will display all IPv6 multicast routing entries.
Restrictions
None. (EI Mode Only Command)
Example
To show the whole IPv6 multicast routing table generated on the switch:
DGS-3620-28PC:admin# show pim6 mroute
Command: show pim6 mroute
Total (*,G) Entries
Total (S,G) Entries
Total (S,G,rpt) Entries:
Group : FF13::100
Source : *
Outgoing : n10 n30
Group : FF13::100
Source : 2001::1111
Outgoing: n10
Group : FF13::102
Source : 2001::3F6D
Outgoing: n20
Group : FF13::100
Source : 2001::1111
RP Address: 3FFE:10:10::153
Outgoing : -
Total Entries: 4
DGS-3620-28PC:admin#
You can check the detailed info for a specific multicasting routing entry by specifying the options in
the command. To show the detailed info of the multicast routing entries for a specific group, you
should specify the group address.
DGS-3620-28PC:admin# show pim6 mroute group FF13::100
Command: show pim6 mroute group FF13::100
: 1
: 2
1
Upstream: n1
Upstream: n2
Upstream: n2
rpt, Upstream: n1
951