D-Link xStack DGS-3620 Reference Manual page 920

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
broadcast_threshold - Specifies the upper threshold, at which point the specified storm control
is triggered. The value is the number of broadcast packets per second received by the switch
that will trigger the storm traffic control measure. The threshold is expressed as PPS (packets
per second) and must be an unsigned integer.
<value 0-255000> - Enter the broadcast threshold value. This value must be between 0 and
255000.
multicast_threshold - Specifies the upper threshold, at which point the specified storm control is
triggered. The value is the number of multicast packets per second received by the switch that
will trigger the storm traffic control measure. The threshold is expressed as PPS (packets per
second) and must be an unsigned integer.
<value 0-255000> - Enter the multicast threshold value. This value must be between 0 and
255000.
unicast_threshold - Specifies the upper threshold, at which point the specified storm control is
triggered. The value is the number of unicast packets per second received by the switch that
will trigger the storm traffic control measure. The threshold is expressed as PPS (packets per
second) and must be an unsigned integer.
<value 0-255000> - Enter the unicast threshold value. This value must be between 0 and
255000.
countdown - The timer for shutdown mode. When a port enters a shutdown RX state, and if this
times out, the port will shut down the port forever. The default is 0 minutes.
<min 0> - Zero is the disable forever state.
<min 3-30> - Enter a value between 3 and 30 minutes.
disable – Specifies that when the action is shutdown and the countdown is disabled, when the
Switch detects a storm, it will shutdown the port directly.
time_interval - The sampling interval of received packet counts. This parameter is meaningless
for dropping packets is selected as action.
<value 5-600> - Enter the value between 5 and 600.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure traffic control and state:
DGS-3620-28PC:admin#config traffic control 1-10 broadcast enable action
shutdown threshold 640 time_interval 10
Command: config traffic control 1-10 broadcast enable action shutdown threshold
640 time_interval 10
Success.
DGS-3620-28PC:admin#
78-2 config traffic control auto_recover_time
Description
This command is used to configure the traffic auto recover time that allowed for a port to recover
from shutdown forever status. The time allowed for auto recovery from shutdown for a port. The
default value is 0, so no auto recovery is possible; the port remains in shutdown forever mode.
This requires manual entry of the CLI command "config ports [ <portlist> | all ] state enable" to
return the port to a forwarding state. The default value is 0, which means disable auto recover
mode, shutdown forever.
915