Config Bgp Router_Id <Ipaddr; Config Bgp Synchronization [Enable | Disable] - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config bgp router_id <ipaddr>
Parameters
<ipaddr> - An ID to identify a BGP router. If it is set to zero the router ID will be automatically
determined. The default value is the highest IP address on a physical interface.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To configure the BGP process's router ID:
DGS-3620-28PC:admin#
Command: config bgp router_id 10.10.10.1
Success
DGS-3620-28PC:admin#
12-6 config bgp synchronization
Description
This command is used to configure the BGP synchronization ability. Usually, a BGP speaker does
not advertise a route to an external neighbor unless that route is local or exists in the IGP. By
default, synchronization between BGP and the IGP is turned off to allow the BGP to advertise a
network route without waiting for route validation from the IGP. This feature allows routers and
access servers within an Autonomous System to have the route before BGP makes it available to
other autonomous systems.
Format

config bgp synchronization [enable | disable]

Parameters
enable - Specifies to enable synchronization.
disable - Specifies to disable synchronization. By default, this setting is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
config bgp router_id 10.10.10.1
170