D-Link xStack DGS-3620 Reference Manual page 898

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
None.
Example
To display OSPF virtual-link neighbor information:
DGS-3620-28PC:admin# show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit
Area ID
---------------
10.1.1.1
Total Entries : 1
DGS-3620-28PC:admin#
76-25 config ospf default-information
Description
This command is used to set the status of originating the OSPF default external route.
Format
config ospf default-information {originate [always | default | none] | mettype [1 | 2] | metric
<value 1-65535>}(1)
Parameters
originate - Specifies the status of originating default information.
always - Specifies that the external default route will be originated, whether a default route
exists or not.
default - Specifies that the external default route will be originated only when one default
route already exists.
none - Specifies that the external default route will never be originated.
mettype - Specifies the type of LSA that contains the default external route imported into OSPF.
1 - Specifies that the default external route will be calculated using the metric by adding the
interface cost to the metric entered in the metric field.
2 - Specifies that the default external route will be calculated using the metric entered in the
metric field without change.
metric - Specifies the metric used by the originating default external route.
<value 1-65535> - Enter the metric used by the originating default external route. This value
must be between 1 and 65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Router ID of
Virtual Neighbor
---------------- ----------------
10.2.3.4
IP Address of
Virtual Neighbor
----------------
10.48.74.111
893
Virtual Neighbor
State
Exchange