D-Link xStack DGS-3620 Reference Manual page 933

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
255.
hash_masklen - Enter a hash mask length, which will be used with the IP address of the
candidate RP and the multicast group address, to calculate the hash algorithm used by the
router to determine which CRP on the PIM-SM enabled network will be the RP.
<value 0-32> - Enter the hash mask lenght value here. This value must be between 0 and 32.
The default value is 30 seconds.
bootstrap_period - Specifies the interval between originating Bootstrap message.
<value 1-255> - Enter the bootstrap period value used here. This value must be between 1
and 255. The default value is 60 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the C-BSR for the System interface :
DGS-3620-28PC:admin# config pim cbsr ipif System priority 255
Command: config pim cbsr ipif System priority 255
Success.
DGS-3620-28PC:admin#
80-7 show pim cbsr
Description
This command is used to list the candidate bootstrap router related information.
Format
show pim cbsr {ipif <ipif_name 12>}
Parameters
ipif - Specifies the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display all C-BSR configurations.
Restrictions
None.
Example
To display the C-BSR settings:
DGS-3620-28PC:admin# show pim cbsr
Command: show pim cbsr
PIM Candidate-BSR Table
928