[{[Ipv4 | Ipv6] Unicast} Activity | State] [Enable | Disable] - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To configure a neighbor's description:
DGS-3620-28PC:admin#
Command: config bgp neighbor 10.10.10.2 description EBGP-neighbor
Success.
DGS-3620-28PC:admin#
12-23 config bgp neighbor session
Description
The command is used to configure the state or neighbor's session activity for a BGP neighbor. If a
neighbor is specified to be in the disabled state, it is equivalent to the case that the neighbor is
deleted except when the neighbor configuration is kept. For activity, it is configured for the IPv4
unicast address family if both IPv4 and IPv6 unicast are not specified.
Format
config bgp neighbor session [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16>]

[{[ipv4 | ipv6] unicast} activity | state] [enable | disable]

Parameters
<ipaddr> - Specifies the IPv4 address of the neighbor to be configured.
<ipv6addr> - Specifies the IPv6 address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
ipv4 unicast - Specifies to configure the IPv4 unicast address family.
ipv6 unicast - Specifies to configure the IPv6 unicast address family.
state - If state is changed from enabled to disabled, the session with the neighbor peer will be
terminated.
activity - Specifies the state for individual address family. By default, the setting is enabled for
IPv4 address family.
enable - Specifies that the neighbor session state or the for individual address family state will be
enabled.
disable - Specifies that the neighbor session state or the for individual address family state will
be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
config bgp neighbor 10.10.10.2 description EBGP-neighbor
187