D-Link xStack DGS-3620 Reference Manual page 912

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<neighbor_id> - (Optional) Specifies the ID of the neighbor.
ipif - (Optional) Specifies the IP interface where the neighbor is built.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
Restrictions
None. (EI Mode Only Command)
Example
To display OSPFv3 neighbor:
DGS-3620-28PC:admin# show ospfv3 neighbor
Command: show ospfv3 neighbor
Router ID of
Neighbor
--------------- ------------ -------- -------------
10.10.10.10
20.20.20.20
Total Entries: 2
DGS-3620-28PC:admin# show ospfv3 neighbor 10.10.10.10 ipif System
Command: show ospfv3 neighbor 10.10.10.10 ipif System
Neighbor ID: 10.10.10.10
Neighbor Options: 19
Neighbor State: Full
Interface ID: 1
DGS-3620-28PC:admin#
77-15 show ospfv3 virtual_neighbor
Description
This command is used to display OSPFv3 virtual neighbor information.
Format
show ospfv3 virtual_neighbor {<area_id> <neighbor_id>}
Parameters
<area_id> - (Optional) Specifies the transit area where the virtual neighbor is built.
<neighbor_id> - (Optional) Specifies the ID of the virtual neighbor. If none of the parameters are
set, all the virtual neighbors will be displayed.
Interface Neighbor Neighbor
Name Priority State
System 1
ip1 10
Full
Full
Interface Name: System
Neighbor Priority: 255
State Changes: 6 times
907