D-Link xStack DGS-3620 Reference Manual page 948

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Success.
DGS-3620-28PC:admin#
81-2 show pim6
Description
This command is used to display the PIM6 configurations.
Format
show pim6 {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the IP interface to be displayed.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display the PIM6 parameters on all IPv6 interfaces in
brief.
Restrictions
None. (EI Mode Only Command)
Example
To show the brief info of the PIM6 protocol concerned parameters on all interfaces:
DGS-3620-28PC:admin# show pim6
Command: show pim6
PIM6 Global State
Last Hop SPT Switchover
Register Probe Interval
Register Suppression Timeout
Keepalive Period
Register Checksum Calculate
Embedded RP State
PIM6-SM Interface Table
DR
Interface Priority
---------- --------
System 1
Total Entries : 1
DGS-3620-28PC:admin#
: Enabled
: Immediately
: 5 sec
: 60 sec
: 210 sec
: Include Data
: Disabled
Hello J/P
Interval Interval
-------- ---------
3 60
943
BSR
State Border
--------- --------
Disabled Disabled