D-Link xStack DGS-3620 Reference Manual page 260

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Port AllPkt CCM
----- -------- -------- -------- --------- ------ ------- -------- --------
All 0 0
1 0 0
2 0 0
CFM TX Statistics
----------------------------------------------------------
Port AllPkt CCM
----- -------- -------- -------- --------- ------ -------
All 0 0
1 0 0
2 0 0
DGS-3620-28PC:admin#
15-26 clear cfm pkt_cnt
Description
This command is used to clear the CFM packet's RX/TX counters.
Format
clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) Specifies the port counters to clear. If not specified, all ports will be cleared.
<portlist> - Enter a list of ports.
rx - (Optional) Clear the RX counter. If not specified, both the RX and TX counters will be
cleared.
tx - (Optional) Clear the TX counter. If not specified, both the RX and TX counters will be
cleared.
rx - (Optional) Clear the RX counter. If not specified, both the RX and TX counters will be
cleared.
tx - (Optional) Clear the TX counter. If not specified, both the RX and TX counters will be cleared.
ccm - (Optional) Clear The CCM RX counters.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To clear all the CFM packet RX/TX counters:
DGS-3620-28PC:admin#clear cfm pkt_cnt
Command: clear cfm pkt_cnt
Success.
LBR LBM LTR
0 0 0
0 0 0
0 0 0
LBR LBM LTR
0 0 0
0 0 0
0 0 0
255
LTM VidDrop OpcoDrop
0 0 0
0 0 0
0 0 0
LTM
0
0
0