D-Link xStack DGS-3620 Reference Manual page 865

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
74-19 config syslog source_ipif
Description
This command is used to force change the ipif information in syslogs. By default, syslogs will carry
the information of the ipif they belong to.
Format
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name. If only this parameter is specified, the IPv4
address and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specifies the IP4 address.
<ipv6addr> - (Optional) Specifies the IPv6 global address.
none - Specifies to clear the configured source IP interface.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the syslog source IP interface:
DGS-3620-28PC:admin#config syslog source_ipif Sysetm
Command: config syslog source_ipif System
Success.
DGS-3620-28PC:admin#
To clear the configured source IP interface for syslog:
DGS-3620-28PC:admin#config syslog source_ipif none
Command: config syslog source_ipif none
Success.
DGS-3620-28PC:admin#
74-20 show syslog source_ipif
Description
This command is used to display the syslog source IP interface.
Format
show syslog source_ipif
860