D-Link xStack DGS-3620 Reference Manual page 166

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
disable bfd
Parameters
None
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example show how to disable the BFD global state.
DGS-3620-28PC:admin# disable bfd
Command: disable bfd
Success.
DGS-3620-28PC:admin#
11-3 config bfd
Description
This command is used to configure the BFD parameters on the Switch.
Format
config bfd [ipif <ipif_name 12> | all] {min_tx_interval <millisecond 50-1000> |
min_rx_interval <millisecond 50-1000> | multiplier <value 3-99> | slow_time <millisecond
1000-3000>}
Parameters
ipif - Specifies the name of the IP interface.
<ipif_name 12> - Enter the name of the IP interface. This name can be up to 12 characters
long.
all - Specifies that all the IP interfaces will be used.
min_tx_interval - (Optional) Specifies the desired minimum transmit interval value.
<millisecond 50-1000> - Enter the minimum transmit interval value here. This value must be
between 50 and 1000 milliseconds.
min_rx_interval - (Optional) Specifies the required minimum receive interval value.
<millisecond 50-1000> - Enter the minimum receive interval value here. This value must be
between 50 and 1000 milliseconds.
multiplier - (Optional) Specifies the BFD detection time multiplier value.
<value 3-99> - Enter the BFD detection time multiplier value here. This value must be
between 3 and 99.
slow_time - (Optional) Specifies the BFD slow time value.
<millisecond 1000-3000> - Enter the BFD slow time value here. This value must be between
1000 and 3000 milliseconds.
161