Config Account - D-Link DGS-1210/ME Series Reference Manual

Restrictions
NOTE: You are not required to enter a User Name. However, if you do not enter a User Name,
you cannot perform the following actions:
Create a monitor or operator (level 1 or level 14) users until an administrator user (level 15) is
defined.
Delete the last administrator user if there are monitor and/or operator users defined.
Example usage:
To create an administrator-level user account with the username 'dlink':
DGS-1210-28MP/ME:5# create account admin dlink
Command: create account admin dlink
Enter a case-sensitive new password:*****
Enter the new password again for confirmation:*****
Success.
DGS-1210-28MP/ME:5#

config account

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the user password of 'dlink' account:
DGS-1210-28MP/ME:5# config account dlink
Enter a old password:****
Enter a case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-1210-28MP/ME:5#
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Only Administrator level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
To change the password for an existing user account.
config account <username 15>
The config account command changes the password for a user
account that has been created using the create account command.
The system prompts for the account's new password, which may be
between 0 and 15 characters.
<username 15> − the account username.
Only Administrator-level users can issue this command.
11