Administering The Primary Controller - Avaya S8500 Installing And Configuring

Administering the primary controller

You must administer the primary controller to enable it to identify and communicate with the
S8500 LSP.
1. At the SAT command line, type change node-names ip <name>, where <name> is
the name of the LSP.
2. In the Name column, type the name of the LSP.
3. In the IP Address column, type the IP address of the LSP.
4. At the SAT command line, type add survivable-processor <name>, where
<name> is the LSP name from the Node Names screen.
The Survivable Processor screen appears.
Figure 7: Add Local Survivable Processor form
add survivable-processor sv-mg2-lsp
5. The Type field is automatically populated with LSP. LSP appears in the field if the node
name is not associated with ESS.
6. Enter a network region for the LSP. The default is 1. However, there may be a different
network region better suited for the LSP to provide media gateway and IP phone support.
7. On pages 2 and 3 of the screen, add any adjuncts that the LSP may support in the event of
a failover from the primary controller.
See Administrator Guide for Avaya Communication Manager for details on administering the
Survivable Processor form.
Installing and Configuring the Avaya S8500 Media Server
SURVIVABLE PROCESSOR - PROCESSOR ETHERNET
Node Name: sv-mg2-lsp
IP Address: 128.256.173.101
Type: LSP
Network Region: 1
Administering the primary controller
Page
February 2006
1 of xx
77