Complete The Upgrade; Copy Announcements (If Necessary); Install Remaining Hardware And Administer The System; Enable Tti - Avaya DEFINITY Server R Manual

Upgrading G3vs to an Avaya DEFINITY Server R
running Avaya MultiVantage Software

Copy Announcements (if necessary)

1. If the system contains a TN750/B Announcement circuit pack, type display
announcements and press
2. If administered recorded announcements are listed, type copy
announcements and press

Complete the Upgrade

Install Remaining Hardware and Administer the
System
If the present system was removed to make room for the MCC1 cabinet, skip to
Step 3.
If the MCC1 cabinet was installed while the present system is in service, return to
''Remove the Present System'' on page
finished.
1. Connect all new and reusable I/O cables to the MCC1 cabinet.
Cross-connect at the MDF as required.
2. Remove all reusable circuit packs from the present system and install into
the MCC1 cabinet. Install any new circuit packs in the cabinet.
3. Install fiber optic cables and administer the fiber links as needed. Refer to
the Made Easy tools.
4. Administer any new translations, as required.

Enable TTI

NOTE:
Do this step only if you disabled the TTI earlier.
1. Type change system-parameters features and press
TTI field back to its value before the upgrade.
3-20
Issue 5 October 2002
NOTE:
The TN750C Announcement circuit pack stores announcements in
non-volatile memory; saving the announcements is not needed.
.
Enter
.
Enter
3-10. Return to this section when
to change the
Enter
555-233-115