Table of Contents
Advertisement
Replacing basic chassis components
2. Power down the server and disconnect all power cords.
3. Loosen the three thumbscrews at the rear of the top cover.
4. Remove the server cover by pulling the cover toward the rear of the chassis, and
5. Clip the lead from your ESD wrist strap to an unpainted metal section of the chassis.
To replace the front bezel after maintenance is complete
When the Avaya CallPilot
Figure 10: Front bezel replaced
1. Align the front bezel with the ball studs located at each faceplate corner.
2. Apply pressure evenly until the bezel snaps onto each ball stud.
3. Close and lock the double doors of the front bezel.
78
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Remove the front bezel.
then lifting it up and off.
®
server maintenance is complete, replace the front bezel.
December 2010
Advertisement
Table of Contents
