Chapter 6: IP interface configuration
Setting the VLAN and diffserv parameters
1. Log in as craft.
2. Enter show qos to display the quality of service values.
3. If necessary, use the following commands to set the VLAN and diffserv parameters to the
recommended values shown.
Note:
Use Help to obtain syntax guidelines for these commands.
Note:
Enter set vlan priority 6
●
Enter set diffserv 46
●
Enter set vlan tag on
●
Enter set port negotiation 1 disable
●
Enter set port duplex 1 full
●
Enter set port speed 1 100
●
4. Enter show qos to check the administered values.
5. Enter quit to exit.
!
Important:
Ensure that the port settings on the Ethernet switches are set to the same values
Important:
as shown above in these set port commands. Log in to the Ethernet switch
and enter show qos.
Resetting the IPSI
1. Type reset and press Enter
Answer Y to the warning.
Note:
Resetting the IPSI terminates the administration session. If further administration
Note:
is required, start a new telnet session.
Note:
Control network settings (IP address, subnet mask, and gateway) become
Note:
effective when you exit the IPADMIN session.
2. Disconnect the laptop from the faceplate.
70
Installing and Configuring the Avaya S8500 Media Server
February 2006