Setting The Vlan And Diffserv Parameters - Avaya S8400 Installing And Configuring

Chapter 6: IP interface configuration
11. Type show control interface and press Enter.
The system displays IP address, subnet mask, and default gateway information.
Verify that the proper information was entered.
12. If a default gateway is used, enter the gateway IP address with
set control gateway gatewayaddr, where gatewayaddr is the customer-provided
IP address for their gateway.
13. Type quit and press Enter to save the changes and exit the SIPI session.
14. Log back in to the SIPI using SSH.
15. Use show control interface to verify the administration.
16. Type exit and press Enter.

Setting the VLAN and diffserv parameters

1. Connect to the SIPI and log in as craft.
2. To display the quality of service values, type show qos and press Enter.
3. Use the set commands in the list below to set the VLAN, diffserv, and port parameters. If
the customer does not specify different values, use these recommended values.
Note:
Use Help to obtain syntax guidelines for these commands.
Note:
!
Important:
The settings for these parameters on the SIPIs must be consistent with the
Important:
settings on the media servers and other network devices such as Ethernet
switches.
set vlan priority 6
●
set diffserv 46
●
● set vlan tag on
● set port negotiation 1 disable
set port duplex 1 full
●
set port speed 1 100
●
4. Type show qos and press Enter to check the administered values.
5. Type reset and press Enter to capture the updated parameter values.
The reset terminates the administration session and automatically logs you out.
6. Log in again and use the show qos command to ensure that the parameter settings are
correct.
44
Installing and Configuring the Avaya S8400 Media Server February 2007