Setting The Vlan And Diffserv Parameters - Avaya S8700 Series Installing And Configuring

3. Type set control interface ipaddr netmask and press Enter, where ipaddr is
the customer-provided IP address and netmask is the customer provided subnet mask.
4. Enter quit to save the changes and exit the IPSI session.
5. Telnet to 192.11.13.6 and login.
6. Enter show control interface.
The IP address, subnet mask, and default gateway information are displayed.
Verify that the proper information was entered.
7. If a default gateway is used, enter the gateway IP address using
set control gateway gatewayaddr, where gatewayaddr is the customer-provided
IP address for their gateway.
8. Enter quit to save the changes and exit the IPSI session.
9. Telnet to 192.11.13.6 and login.
10. Use show control interface to verify the administration.
11. Type exit and press Enter to see the changes.

Setting the VLAN and diffserv parameters

The following steps sets the VLAN and diffserv parameters.
1. Log back in as craft.
2. Enter show qos to display the quality of service values.
Programming the IPSI circuit packs
Issue 4.1 June 2005 65