Upgrading Small System hardware
Page 85 of 226
Gateway Controller installation
Reuse the existing 3-port SDI cable (NTBK48) for installation of a Gateway
Controller in a MG 1000E cabinet or chassis. Connect it to the SDI port on
the cabinet and the COM RS232 port on the chassis. Figure on
page 85
illustrates the two connectors.
Figure 12
NTBK48 connectors
The 3-port SDI cable is not required for a Gateway Controller installation in
a MG 1010 chassis. The MG 1010 MGU card faceplate ports provide the
serial connectors. Use the NTC325AAE6 serial port adapter with a MG 1010.
Avaya Communication Server 1000E Upgrade
Hardware Upgrade Procedures