Chapter 9 Auto-Configuration Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 9
enable autoconfig
disable autoconfig
show autoconfig
config autoconfig timeout <value 1-65535>
9-1 enable autoconfig
Description
This command is used to enable auto-configuration. When enabled, during power on initialization, the Switch will
get configure file path name and TFTP server IP address from the DHCP server. Then, the Switch will download
the configuration file from the TFTP server for configuration of the system.
Format
enable autoconfig
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable auto-configuration:
DGS-1510-28XMP/ME:admin# enable autoconfig
Command: enable autoconfig
Success.
DGS-1510-28XMP/ME:admin#
9-2 disable autoconfig
Description
This command is used to disable auto-configuration. When disabled, the Switch will configure itself using the local
configuration file
Format
disable autoconfig
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Auto-Configuration Command List
98