D-Link DGS-1510/ME Series Reference Manual page 24

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
slave - Specifies that the port(s) will be set to slave.
10g_full - Specifies the port speed to 10g_full.
flow_control - (Optional) Specifies to turn on or turn off flow control on one or more ports.
enable - Specifies that the flow control option will be enabled.
disable - Specifies that the flow control option will be disabled.
learning - (Optional) Specifies to turn on or turn off MAC address learning on one or more ports.
enable - Specifies that the learning option will be enabled.
disable - Specifies that the learning option will be disabled.
state - (Optional) Specifies to enable or disable the specified port. If the specified ports are in error-disabled
status , configure their state to enable will recover these ports from disabled to enable state.
enable - Specifies that the port state will be enabled.
disable - Specifies that the port state will be disabled.
mdix - (Optional) Specifies the MDIX mode.
auto - Specifies the MDIX mode for the port to be auto.
normal - Specifies the MDIX mode for the port to be normal. If set to normal state, the port is in the MDIX
mode and can be connected to a PC's NIC using a straight-through cable or a port (in the MDIX mode) on
another switch through a cross-over cable.
cross - Specifies the MDIX mode for the port to be cross. If set to cross state, the port is in the MDI mode and
can be connected to a port (in the MDIX mode) on another switch through a straight cable.
description - (Optional) Specifies the description of the port interface.
<desc 1-32> - Enter the port interface description here. This value can be up to 32 characters long.
clear_description - (Optional) Specifies that the description field will be cleared.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the ports:
DGS-1510-28XMP/ME:admin# config ports all medium_type copper speed auto
Command: config ports all medium_type copper speed auto
Success.
DGS-1510-28XMP/ME:admin#
2-18 show ports
Description
This command is used to display the current configurations of a range of ports.
Format
show ports {<portlist>} {[description | err_disabled | details | media_type]}
20