Chapter 70 System Log Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 70 System Log Command List

clear log
show log {[index <value_list> | severity {module <module_list>} {emergency | alert | critical | error | warning |
notice | informational | debug | <level_list 0-7>} | module<module_list>]}
show log_software_module
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> ipaddress <ipaddr> {severity [emergency | alert | critical | error | warning | notice
| informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | state [enable | disable]}
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning | notice | informational |
debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
show attack_log {index <value_list>}
clear attack_log
70-1 clear log
Description
This command is used to clear the Switch's history log.
Format
clear log
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To clear the Switch's history log:
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
578