D-Link DGS-1510/ME Series Reference Manual page 21

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Restrictions
Only Administrators and Operators can issue this command.
Example
To display greeting message:
DGS-1510-28XMP/ME:admin#show greeting_message
Command: show greeting_message
================================================================================
Copyright(C) 2015 D-Link Corporation. All rights reserved.
================================================================================
DGS-1510-28XMP/ME:admin#
2-14 config command_prompt
Description
This command is used to modify the command prompt.
The current command prompt consists of four parts: "product name" + ":" + "user level" + "#" (e.g. "DGS-1510-
28XMP/ME:admin# "). This command is used to modify the first part (1. "product name") with a string consisting of
a maximum of 16 characters, or to be replaced with the users' login user name.
When issuing the reset command, the current command prompt will remain the same. However, when issuing the
reset system command, the command prompt will return to its original factory default value.
Format
config command_prompt [<string 16> | username | default]
Parameters
<string 16> - Enter the new command prompt string of no more than 16 characters.
username - Specifies to set the login username as the command prompt.
default - Specifies to return the command prompt to its original factory default value.
Restrictions
Only Administrators and Operators can issue this command.
Example
To edit the command prompt:
DGS-1510-28XMP/ME Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.018
17