D-Link DGS-1510/ME Series Reference Manual page 591

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
70-12 show log_save_timing
Description
This command is used to show the method for saving the log.
Format
show log_save_timing
Parameters
None.
Restrictions
None.
Example
To show the timing method used for saving the log:
DGS-1510-28XMP/ME:admin# show log_save_timing
Command: show log_save_timing
Saving Log Method: On_demand
DGS-1510-28XMP/ME:admin#
70-13 show attack_log
Description
This command is used to display the attack log messages. The attack log message refers to log messages driven
by modules such as DOS and the IP-MAC-port binding module. This type of log message may generate a large
amount of messages and quickly cause the system to run out of system log storage. Therefore, for this type of log
messages only the first log that is generated each minute can be stored in the system log, with the rest of them
being stored in a separate table named attack log.
Format
show attack_log {index <value_list>}
Parameters
index - (Optional) Specifies the list of index numbers of the entries that need to be displayed. For example, show
attack_log index 1-5 will display the attack log messages from 1 to 5.
<value_list> - Enter the index numbers of the entries that needs to be displayed here.
If no parameter is specified, all entries in the attack log will be displayed.
Restrictions
None.
587