D-Link DGS-1510/ME Series Reference Manual page 563

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Example
To disable the sending of linkchange traps:
DGS-1510-28XMP/ME:admin# disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-1510-28XMP/ME:admin#
67-29 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for sending of change trap.
Format
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Parameters
all - Specifies to configure all ports.
<portlist> - Enter a range of ports to be configured.
enable - Specifies to enable sending of the link change trap for this port.
disable - Specifies to disable sending of the link change trap for this port.
Restrictions
Only Administrators can issue this command.
Example
To configure the sending of linkchange traps:
DGS-1510-28XMP/ME:admin# config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
DGS-1510-28XMP/ME:admin#
67-30 config snmp coldstart_traps
Description
This command is used to configure the trap for coldstart event.
559