D-Link DGS-1510/ME Series Reference Manual page 471

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Parameters
ports - Specifies the list of ports whose setting is under configuration.
all - Specifies that all the ports will be included in this configuration.
<portlist> - Enter the list of ports used for this configuration here.
state - (Optional) Specifies to enable or disable the power supply to the powered device of the specific ports.
enable - Specifies that state will be enabled.
disable - Specifies that state will be disabled.
time_range - (Optional) Specifies the time range that applies to the port of the POE. If time range is configured,
the power can only be supplied during the period specified by time range.
<range_name 32> - Enter the time range name here. This name can be up to 32 characters long.
clear_time_range - (Optional) Specifies to remove the time range.
priority - (Optional) Specifies the priority that the system attempts to supply power to the specific ports. There are
three levels of priority that can be selected, critical, high, and low. When multiple ports happen to have the
same level of priority, the port ID will be used to determine the priority. The lower port ID has higher priority.
The setting of priority will affect the ordering of supplying power. Whether the disconnect_method is set to
deny_low_priority_port, priority of port will be used by the system to manage to supply power to ports.
critical - Specifies that the priority will be set to critical.
high - Specifies that the priority will be set to high.
low - Specifies that the priority will be set to low.
power_limit - (Optional) Specifies to configure the per-port power limit. If a port exceeds its power limit, it will be
shut down.
class_0 - Specifies that the power limit will be set to class 0.
class_1 - Specifies that the power limit will be set to class 1.
class_2 - Specifies that the power limit will be set to class 2.
class_3 - Specifies that the power limit will be set to class 3.
user_define - (Optional) Specifies that a user defined per-port power limit will be used.
<value 1000-35000> - Enter the user defined per-port power limit here. This value must be between m and n.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To config PoE port:
DGS-1510-28XMP/ME:admin# config poe ports 1-4 state enable priority critical power_li
mit class_1
Command: config poe ports 1-4 state enable priority critical power_limit class_1
Success.
DGS-1510-28XMP/ME:admin# config poe ports 5 state enable priority critical power_lim
it user_define 1000
Command: config poe ports 5 state enable priority critical power_limit user_define 1000
Success.
DGS-1510-28XMP/ME:admin#
467