D-Link DGS-1510/ME Series Reference Manual page 163

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Example
To show the CFM Remote MEP information:
DGS-1510-28XMP/ME:admin# show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID
MAC Address
Status
RDI
Port State
Interface Status
Last CCM Serial Number
Sender Chassis ID
Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161
Detect Time
DGS-1510-28XMP/ME:admin#
16-25 show cfm pkt_cnt
Description
This command is used to show the CFM packet's RX/TX counters.
Format
show cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) Specifies the port counters to show. If not specified, all ports will be shown.
<portlist> - Enter the list of ports used for this configuration here.
rx - (Optional) Specifies to display the RX counter.
tx - (Optional) Specifies to display the TX counter. If not specified, both of them will be shown.
rx - (Optional) Specifies to display the RX counter.
tx - (Optional) Specifies to display the TX counter. If not specified, both of them will be shown.
ccm - (Optional) Specifies the CCM RX counters.
Restrictions
None.
Example
To show the CFM packet's RX/TX counters:
: 2
: 00-11-22-33-44-02
: OK
: Yes
: Blocked
: Down
: 1000
: 00-11-22-33-44-00
: 2008-01-01 12:00:00
159