D-Link DGS-1510/ME Series Reference Manual page 616

Table of Contents

Advertisement

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
countdown - (Optional) Specifies timer for shutdown mode. If a port enters the shutdown Rx state and this timer
runs out, port will be shutdown forever. The parameter is not applicable if "drop" (mode) is specified for the
"action" parameter.
<min 0> - Enter 0 to disable the forever state, which means that the port will not enter the shutdown forever
state.
<min 3-30> - Enter the countdown timer value here. This value must be between 3 and 30.
disable - Specifies that the countdown timer will be disabled.
time_interval - (Optional) Specifies the sampling interval of received packet counts. The possible value will be m-
n seconds. The parameter is not applicable if "drop" (mode) is specified for the "action" parameter.
<sec 5-600> - Enter the time interval value here. This value must be between 5 and 600.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the parameters so that the traffic control status is enabled on ports 1-12:
DGS-1510-28XMP/ME:admin# config traffic control 1-12 broadcast enable action shutdown
threshold 1 countdown 5 time_interval 10
Command: config traffic control 1-12 broadcast enable action shutdown threshold
1 countdown 5 time_interval 10
Success.
DGS-1510-28XMP/ME:admin#
76-2
config traffic trap
Description
This command is used to configure trap modes.
Occurred Mode: This trap is sent when a packet storm is detected by the packet storm mechanism.
Cleared Mode: This trap is sent when the packet storm is cleared by the packet storm mechanism.
Format
config traffic trap [none | storm_occurred | storm_cleared | both]
Parameters
none - Specifies that no trap state is specified for storm control.
storm_occurred - Specifies that occurred mode is enabled and cleared mode is disabled.
storm_cleared - Specifies that occurred mode is disabled and cleared mode is enabled.
both - Specifies that both occurred and cleared modes are enabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
612

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents