D-Link DGS-1510/ME Series Reference Manual page 137

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin#show config modified
Command: show config modified
#-------------------------------------------------------------------------------
#
#
#
#
# Copyright(C) 2015 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# DEVICE
# BASIC
# ACCOUNT LIST
# ACCOUNT END
# PASSWORD ENCRYPTION
# DEBUG
CTRL+C ESC q Quit
15-2 config configuration
Description
This command is used to select a configuration file as the next boot up configuration or to apply a specific
configuration to the system. This command is required when multiple configuration files are supported.
Format
config configuration <pathname 64> [boot_up | active]
Parameters
<pathname 64> - Specifies a configuration file on the device file system.
boot_up - Specifies it as a boot up file.
active - Specifies to apply the configuration.
Restrictions
Only Administrators can issue this command.
Example
To configure the Switch's configuration file as boot up:
DGS-1510-28XMP/ME Gigabit Ethernet Switch
Configuration
Firmware: Build 1.00.018
SPACE n Next Page ENTER Next Entry a All
133