D-Link DGS-1510/ME Series Reference Manual page 14

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Format
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never | 2_minutes | 5_minutes |
10_minutes | 15_minutes]}
Parameters
baud_rate - (Optional) Specifies the serial bit rate that will be used to communicate with the management host.
The default baud rate is 115200.
9600 - Specifies the serial bit rate to be 9600.
19200 - Specifies the serial bit rate to be 19200.
38400 - Specifies the serial bit rate to be 38400.
115200 - Specifies the serial bit rate to be 115200.
auto_logout - (Optional) Specifies the auto logout time out setting.
never - Never timeout.
2_minutes - Specifies that the device will auto logout when idle over 2 minutes.
5_minutes - Specifies that the device will auto logout 2hen idle over 5 minutes.
10_minutes - Specifies that the device will auto logout when idle over 10 minutes.
15_minutes - Specifies that the device will auto logout when idle over 15 minutes.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure baud rate:
DGS-1510-28XMP/ME:admin# config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DGS-1510-28XMP/ME:admin#
2-4 enable clipaging
Description
This command is used to enable the pausing of the screen display when the show command output reaches the
end of the page. The default setting is enabled.
Format
enable clipaging
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
10