D-Link DGS-1510/ME Series Reference Manual page 505

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Parameters
<portlist> - Enter a list of ports used for this configuration.
all - Specifies that the command apply to all ports on the Switch.
state - Enable or disable to trust DSCP.
enable - Specifies that the DSCP trust state will be enabled.
disable - Specifies that the DSCP trust state will be disabled. This is the default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Enable DSCP trust on ports 1-8.
DGS-1510-28XMP/ME:admin# config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
DGS-1510-28XMP/ME:admin#
60-19 show dscp trust
Description
This command is used to display DSCP trust state for the specified ports on the Switch.
Format
show dscp trust {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to display.
If no parameter is specified, all ports for DSCP trust status on the Switch will be displayed.
Restrictions
None.
Example
Display DSCP trust status on ports 1-8.
501