D-Link DGS-1510/ME Series Reference Manual page 389

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin# create mld_snooping static_group vlan default FF1E::1
Command: create mld_snooping static_group vlan default FF1E::1
Success.
DGS-1510-28XMP/ME:admin#
45-12 delete mld_snooping static_group
Description
This command is used to delete a MLD Snooping multicast static group.
Format
delete mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
Parameters
vlan - Specifies the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters long.
vlanid - Specifies the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - Enter the multicast group IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete an MLD snooping static group for VLAN 1, group FF1E::1:
DGS-1510-28XMP/ME:admin# delete mld_snooping static_group vlan default FF1E::1
Command: delete mld_snooping static_group vlan default FF1E::1
Success.
DGS-1510-28XMP/ME:admin#
45-13 config mld_snooping static_group
Description
This command is used to configure an MLD snooping multicast group static member port. When a port is
configured as a static member port, the MLD protocol will not operate on this port. For example, suppose that a
port is a dynamic member port learned by MLD. If this port is configured as a static member later, then the MLD
protocol will stop operating on this port. The MLD protocol will resume once this port is removed from static
member ports.
385