D-Link DGS-1510/ME Series Reference Manual page 226

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
2. The Ring port is the tagged member port of the R-APS VLAN.
3. The RPL port is specified if RPL owner is enabled.
Format
config erps raps_vlan <vlanid> [state [enable | disable] | ring_mel <value 0-7> | ring_port [west <port> |
east <port> ] | rpl_port [west | east | none] | rpl_owner [enable | disable] | protected_vlan [add | delete]
vlanid <vidlist> | revertive [enable | disable] | timer {holdoff_time <millisecond 0 - 10000> | guard_time
<millisecond 10 - 2000> | wtr_time <min 5 - 12>}]
Parameters
<vlanid> - Enter the R-APS VLAN ID used.
state - Specifies to enable or disable the specified ring.
enable - Specifies to enable the state of the specified ring.
disable - Specifies to disable the state of the specified ring. The default value is disabled.
ring_mel - Specifies the ring MEL of the R-APS function. The default ring MEL is 1.
<value 0-7> - Enter the ring MEL value here. This value should be between 0 and 7.
ring_port - Specifies the ring port used.
west - Specifies the port as the west ring port.
<port> - Enter the port number here.
east - Specifies the port as the east ring port.
<port> - Enter the port number here.
rpl_port - Specifies the RPL port used.
west - Specifies the west ring port as the RPL port.
east - Specifies the east ring port as the RPL port.
none - Specifies that there is no RPL port on this node. By default, the node has no RPL port.
rpl_owner - Specifies to enable or disable the RPL owner node.
enable - Specifies the device as an RPL owner node.
disable - Specifies that the node is not an RPL owner. By default, the RPS owner is disabled.
protected_vlan - Specifies to add or delete the protected VLAN group.
add - Specifies to add VLANs to the protected VLAN group.
delete - Specifies to delete VLANs from the protected VLAN group.
vlanid - Specifies the VLAN ID to be removed or added.
<vidlist> - Enter the VLAN ID list here.
revertive - Specifies the state of the R-APS revertive option.
enable - Specifies that the R-APS revertive option will be enabled.
disable - Specifies that the R-APS revertive option will be disabled.
timer - Specifies the R-APS timer used.
holdoff_time - (Optional) Specifies the hold-off time of the R-APS function. The default hold-off time is 0
milliseconds.
<millisecond 0-10000> - Enter the hold off time value here. This value must be in the range of 0 to 10000
milliseconds.
guard_time - (Optional) Specifies the guard time of the R-APS function. The default guard time is 500
milliseconds.
<millisecond 10-2000> - Enter the guard time value here. This value must be in the range of 0 to 2000
milliseconds.
wtr_time - (Optional) Specifies the WTR time of the R-APS function.
<min 5-12> - Enter the WTR time range value here. The range is from 5 to 12 minutes. The default WTR
time is 5 minutes.
222