D-Link DGS-1510/ME Series Reference Manual page 314

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
enable - Specifies to enable the specified link aggregation group.
disable - Specifies to disable the specified link aggregation group.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To define a load-sharing group of ports:
DGS-1510-28XMP/ME:admin# config link_aggregation group_id 1 master_port 5 ports 5-7
Command: config link_aggregation group_id 1 master_port 5 ports 5-7
Success.
DGS-1510-28XMP/ME:admin#
37-4 config link_aggregation algorithm
Description
This command is used to configure the part of the packet examined by the Switch when selecting the egress port
for transmitting load-sharing data. This feature is available using the address-based load-sharing algorithm, only.
Format
config link_aggregation algorithm [mac_source | mac_destination|mac_source_dest | ip_source |
ip_destination | ip_source_dest]
Parameters
mac_source - Specifies that the Switch should examine the MAC source address.
mac_destination - Specifies that the Switch should examine the MAC destination address.
mac_source_dest - Specifies that the Switch should examine the MAC source and destination address.
ip_source - Specifies that the Switch should examine the IP source address.
ip_destination - Specifies that the Switch should examine the IP destination address.
ip_source_dest - Specifies that the Switch should examine the IP source address and destination address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure link aggregation algorithm for mac-source-dest:
310