D-Link DGS-1510/ME Series Reference Manual page 349

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Restrictions
None.
Example
To show the LBD settings on ports 1-9:
DGS-1510-28XMP/ME:admin# show loopdetect
Command: show loopdetect
Port Loopdetect State
------ ------------------ ----------
1 Enabled
2 Enabled
3 Enabled
4 Enabled
5 Enabled
6 Enabled
7 Enabled
8 Enabled
9 Enabled
DGS-1510-28XMP/ME:admin#
40-7 config loopdetect trap
Description
This command is used to configure the trap modes for LBD.
Format
config loopdetect trap [none | loop_detected | loop_cleared | both]
Parameters
none - Specifies that there is no trap in the LBD function.
loop_detected - Specifies that trap will only be sent when the loop condition is detected.
loop_cleared - Specifies that trap will only be sent when the loop condition is cleared.
both - Specifies that trap will either be sent when the loop condition is detected or cleared.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To specify that traps will be sent when the loop condition is detected or cleared:
ports 1-9
ports 1-9
Loop Status
Normal
Normal
Normal
Normal
Loop!
Normal
Loop!
Normal
Normal
345