Chapter 9 Auto-Configuration Command List - D-Link X-STACK DES-3200 SERIES Reference Manual

®
xStack DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
Chapter 9
enable autoconfig
disable autoconfig
show autoconfig
config autoconfig timeout <value 1-65535>
9-1 enable autoconfig
Description
This command is used to enable auto configuration. When enabled, during power on initialization,
the Switch will get configure file path name and TFTP server IP address from the DHCP server.
Then, the Switch will download the configuration file from the TFTP server for configuration of the
system.
Format
enable autoconfig
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable autoconfig:
DES-3200-28P:admin#enable autoconfig
Command: enable autoconfig
Success.
DES-3200-28P:admin#
9-2 disable autoconfig
Description
This command is used to disable auto configuration. When disabled, the Switch will configure itself
using the local configuration file
Auto-Configuration
Command List
109