Clear Counters - D-Link DGS-1510/ME Series Reference Manual

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Example
To display FLASH utilization:
DGS-1510-28XMP/ME:admin#show utilization flash
Command: show utilization flash
Flash Memory Utilization :
Total Flash
Used Flash
Utilization
CTRL+C ESC q Quit
51-6

clear counters

Description
This command is used to clear the Switch's statistics counters.
Format
clear counters {ports <portlist>}
Parameters
ports - (Optional) Specifies a range of ports to be configured. The port list is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a colon. Then
highest switch number, and the highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by a dash.
<portlist> - Enter a list of ports used for the configuration here.
If no parameter is specified, system will display counters of all the ports .
Restrictions
Only Administrators and Operators can issue this command.
Example
To clear the Switch's statistics counters:
DGS-1510-28XMP/ME:admin# clear counters ports 7-9
Command: clear counters ports 7-9
Success.
DGS-1510-28XMP/ME:admin#
: 29937 KB
: 28834 KB
: 96 %
SPACE n Next Page p Previous Page r Refresh
444