D-Link DGS-1510/ME Series Reference Manual page 362

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Parameters
guest_vlan - Specifies the name of the MAC-based Access Control's guest VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
guest_vlanid - Specifies the VID of the MAC-based Access Control's guest VLAN.
<vlanid 1-4094> - Enter the VLAN ID here. This value must be between 1 and 4094.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete the MAC-based Access Control guest VLAN called default:
DGS-1510-28XMP/ME:admin# delete mac_based_access_control guest_vlan default
Command: delete mac_based_access_control guest_vlan default
Success.
DGS-1510-28XMP/ME:admin#
42-9 clear mac_based_access_control auth_state
Description
This command is used to clear the authentication state of a user (or port). The port (or the user) will return to an
un-authenticated state. All the timers associated with the port (or the user) will be reset.
Format
clear mac_based_access_control auth_state [ports [all | <portlist>] | mac_addr <macaddr>]
Parameters
ports - Specifies the port range to delete MAC addresses on them.
all - Specifies all MAC-based Access Control enabled ports to delete MAC addresses.
<portlist> - Enter the list of ports used for this configuration here.
mac_addr - Specifies to delete a specified host with this MAC address.
<macaddr> - Enter the MAC address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear MAC-based Access Control clients' authentication information for all ports:
358