D-Link DGS-1510/ME Series Reference Manual page 23

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Format
show terminal width
Parameters
None.
Restrictions
None.
Example
To display the configuration of current terminal width:
DGS-1510-28XMP/ME:admin# show terminal width
Command: show terminal width
Global terminal width
Current terminal width
DGS-1510-28XMP/ME:admin#
2-17 config ports
Description
This command is used to configure the Switch's port settings.
Format
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto | 10_half | 10_full | 100_half |
100_full | 1000_full {[master | slave]} | 10g_full] | flow_control [enable | disable] | learning [enable | disable]
| state [enable | disable] | mdix [auto | normal | cross] | [description <desc 1-32> | clear_description]}
Parameters
<portlist> - Enter a list of ports used here.
all - Specifies that all the ports will be used for this configuration.
medium_type - (Optional) Specifies the medium type while the configure ports are combo ports.
fiber - Specifies that the medium type will be set to fiber.
copper - Specifies that the medium type will be set to copper.
speed - (Optional) Specifies the port speed of the specified ports.
auto - Specifies the port speed to auto negotiation.
10_half - Specifies the port speed to 10_half.
10_full - Specifies the port speed to 10_full.
100_half - Specifies the port speed to 100_half.
100_full - Specifies the port speed to 100_full.
1000_full - Specifies the port speed to 1000_full. While set port speed to 1000_full,user should specify master
or slave mode for 1000 base TX interface, and leave the 1000_full without any master or slave setting for
other interface.
master - Specifies that the port(s) will be set to master.
: 80
: 80
19